Atmos. Chem. Phys. Discuss., 7, 2819-2856, 2007
www.atmos-chem-phys-discuss.net/7/2819/2007/
doi:10.5194/acpd-7-2819-2007
© Author(s) 2007. This work is licensed under the
Creative Commons Attribution-NonCommercial-ShareAlike 2.5 License.
Review Status
This discussion paper has been under review for the journal Atmospheric Chemistry and Physics (ACP). Please refer to the corresponding final paper in ACP.
Evaluation of a coupled dispersion and aerosol process model against measurements near a major road
M. A. Pohjola1, L. Pirjola2,3, A. Karppinen1, J. Härkönen1, M. Ketzel4, and J. Kukkonen1
1Finnish Meteorological Institute, Air Quality Research, Helsinki, Finland
2Helsinki Polytechnic, Department of Technology, Helsinki, Finland
3University of Helsinki, Department of Physical Sciences, Helsinki, Finland
4National Environmental Research Institute, Department of Atmospheric Environment, Roskilde, Denmark

Abstract. A field measurement campaign was conducted near a major road "Itäväylä" in an urban area in Helsinki in 17–20 February 2003. Aerosol measurements were conducted using a mobile laboratory "Sniffer" at various distances from the road, and at an urban background location. Measurements included particle size distribution in the size range of 7 nm–10 μm (aerodynamic diameter) by the Electrical Low Pressure Impactor (ELPI) and in the size range of 3–50 nm (mobility diameter) by Scanning Mobility Particle Sizer (SMPS), total number concentration of particles larger than 3 nm detected by an ultrafine condensation particle counter (UCPC), temperature, relative humidity, wind speed and direction, driving route of the mobile laboratory, and traffic density on the studied road. In this study, we have compared measured concentration data with the predictions of the road network dispersion model CAR-FMI used in combination with an aerosol process model MONO32. The vehicular exhaust emissions, and atmospheric dispersion and transformation of fine and ultrafine particles was evaluated within the distance scale of 200 m (corresponding to a time scale of a couple of minutes). We computed the temporal evolution of the number concentrations, size distributions and chemical compositions of various particle size classes. The atmospheric dilution rate of particles is obtained from the roadside dispersion model CAR-FMI. Considering the evolution of total number concentration, dilution was shown to be the most important process. The influence of coagulation and condensation on the number concentrations of particle size modes was found to be negligible at this distance scale. Condensation was found to affect the evolution of particle diameter in the two smallest particle modes. The assumed value of the concentration of condensable organic vapour of 1012 molecules cm−3 was shown to be in a disagreement with the measured particle size evolution, while the modelling runs with the concentration of condensable organic vapour of 109–1010 molecules cm−3 resulted in particle sizes that were closest to the measured values.

Citation: Pohjola, M. A., Pirjola, L., Karppinen, A., Härkönen, J., Ketzel, M., and Kukkonen, J.: Evaluation of a coupled dispersion and aerosol process model against measurements near a major road, Atmos. Chem. Phys. Discuss., 7, 2819-2856, doi:10.5194/acpd-7-2819-2007, 2007.
 
Search ACPD
Discussion Paper
    XML
    Citation
    Final Revised Paper
    Share