Atmospheric Chemistry and Physics Discussions www.atmos-chem-phys-discuss.net 1680-7367 1680-7375 6 6 2006 10.5194/acpd-6-12057-2006 http://www.atmos-chem-phys-discuss.net/6/12057/2006/ http://www.atmos-chem-phys-discuss.net/6/12057/2006/acpd-6-12057-2006.html http://www.atmos-chem-phys-discuss.net/6/12057/2006/acpd-6-12057-2006.pdf 12057 12120 2006-11-27 Surface tensions of multi-component mixed inorganic/organic aqueous systems of atmospheric significance: measurements, model predictions and importance for cloud activation predictions D. O. Topping G. B. McFiggans G. Kiss Z. Varga M. C. Facchini S. Decesari M. Mircea School of Earth, Atmospheric and Environmental Sciences, The University of Manchester, The Sackville street building, Sackville street, Manchester, M60 1QD, UK Air Chemistry Group of the Hungarian Academy of Sciences, University of Pannonia, 8201 Veszprém, P.O. Box 158, Hungary Department of Earth and Environmental Sciences, University of Pannonia, 8201 Veszprém, P.O. Box 158, Hungary Instituto di Scienze dell Atmosfera e del Clima, Consiglio Nazionale delle Ricerche, Via Gobetti, Bologna, Italy In order to predict the physical properties of aerosol particles, it is necessary to adequately capture the behaviour of the ubiquitous complex organic components. One of the key properties which may affect this behaviour is the contribution of the organic components to the surface tension of aqueous particles in the moist atmosphere. Whilst the qualitative effect of organic compounds on solution surface tensions has been widely reported, our quantitative understanding on mixed organic and mixed inorganic/organic systems is limited.  Furthermore, it is unclear whether models that exist in the literature can reproduce the surface tension variability for binary and higher order multi-component organic and mixed inorganic/organic systems of atmospheric significance. The current study aims to resolve both issues to some extent. Surface tensions of single and multiple solute aqueous solutions were measured and compared with predictions from a number of model treatments. On comparison with binary organic systems, two predictive models found in the literature provided a range of values resulting from sensitivity to calculations of pure component surface tensions.  Results indicate that a fitted model can capture the variability of the measured data very well, producing the lowest average percentage deviation for all compounds studied.  The performance of the other models varies with compound and choice of model parameters. The behaviour of ternary mixed inorganic/organic systems was unreliably captured by using a predictive scheme and this was composition dependent. For more "realistic" higher order systems, entirely predictive schemes performed poorly. It was found that use of the binary data in a relatively simple mixing rule, or modification of an existing thermodynamic model with parameters derived from binary data, was able to accurately capture the surface tension variation with concentration. Thus, it would appear that in order to model multi-component surface tensions involving compounds used in this study one requires the use of appropriate binary data. The effect of deviations between predicted and measured surface tensions on predicted cloud activation properties was quantified, by incorporating the surface tension models into an existing thermodynamic framework. Critical saturation ratios as a function of dry size for all of the multi-component systems were computed and it was found that deviations between predictions increased with decreasing particle dry size.  As expected, use of the surface tension of pure water, rather than calculate the influence of the solutes explicitly, led to a consistently higher value of the critical saturation ratio indicating that neglect of the compositional effects will lead to significant differences in predicted activation behaviour even at large particle dry sizes.