Atmos. Chem. Phys. Discuss., 5, 9405-9445, 2005
www.atmos-chem-phys-discuss.net/5/9405/2005/
doi:10.5194/acpd-5-9405-2005
© Author(s) 2005. This work is licensed under the
Creative Commons Attribution-NonCommercial-ShareAlike 2.5 License.
Review Status
This discussion paper has been under review for the journal Atmospheric Chemistry and Physics (ACP). Please refer to the corresponding final paper in ACP.
Sensitivity analysis of methane emissions derived from SCIAMACHY observations through inverse modelling
J. F. Meirink, H. J. Eskes, and A. P. H. Goede
Climate Research and Seismology Department, Royal Netherlands Meteorological Institute (KNMI), De Bilt, The Netherlands

Abstract. Satellite observations of trace gases in the atmosphere offer a promising method for global verification of emissions and improvement of global emission inventories. Here, an inverse modelling approach based on four-dimensional variational (4D-var) data assimilation is presented and applied to synthetic measurements of atmospheric methane. In this approach emissions and initial concentrations are optimised simultaneously, thus allowing inversions to be carried out on time scales of weeks to months, short compared with the lifetime of methane. Observing System Simulation Experiments (OSSEs) have been performed to demonstrate the feasibility of the method and to investigate the utility of SCIAMACHY observations for methane source estimation. The impact of a number of parameters on the error in the methane emission field retrieved has been analysed. These parameters include the measurement error, the error introduced by the presence of clouds, and the spatial resolution of the emission field. It is shown that 4D-var is an efficient method to deal with large amounts of satellite data and to retrieve emissions at high resolution. Some important conclusions regarding the SCIAMACHY measurements can be drawn: (i) the observations at their estimated precision of 1.5 to 2% will contribute considerably to uncertainty reduction in monthly, subcontinental (~500 km) methane source strengths; (ii) it is essential to take partly cloudy pixels into account in order to achieve sufficient spatial coverage; and (iii) the uncertainty in measured cloud parameters may at some point become the limiting factor, rather than the uncertainty in measured methane.

Citation: Meirink, J. F., Eskes, H. J., and Goede, A. P. H.: Sensitivity analysis of methane emissions derived from SCIAMACHY observations through inverse modelling, Atmos. Chem. Phys. Discuss., 5, 9405-9445, doi:10.5194/acpd-5-9405-2005, 2005.
 
Search ACPD
Discussion Paper
    XML
    Citation
    Final Revised Paper
    Share