Atmos. Chem. Phys. Discuss., 4, 8677-8726, 2004
www.atmos-chem-phys-discuss.net/4/8677/2004/
doi:10.5194/acpd-4-8677-2004
© Author(s) 2004. This work is licensed under the
Creative Commons Attribution-NonCommercial-ShareAlike 2.5 License.
Review Status
This discussion paper has been under review for the journal Atmospheric Chemistry and Physics (ACP). Please refer to the corresponding final paper in ACP.
A curved multi-component aerosol hygroscopicity model framework: 2 – Including organics
D. O. Topping, G. B. McFiggans, and H. Coe
School of Earth, Atmospheric and Environmental Sciences, The University of Manchester, The Sackville street building, Sackville street, Manchester M60 1QD, UK

Abstract. This paper describes the inclusion of organic particulate material within the Aerosol Diameter Dependent Equilibrium Model (ADDEM) framework described in the companion paper applied to inorganic aerosol components. The performance of ADDEM is analysed in terms of its capability to reproduce the behaviour of various organic and mixed inorganic/organic systems using recently published bulk data. Within the modelling architecture already described two separate thermodynamic models are coupled in an additive approach and combined with a method for solving the Köhler equation in order to develop a tool for predicting the water content associated with an aerosol of known inorganic/organic composition and dry size. For development of the organic module, the widely used group contribution method UNIFAC is employed to explicitly deal with the non-ideality in solution. The UNIFAC predictions for components of atmospheric importance were improved considerably by using revised interaction parameters derived from electro-dynamic balance studies. Using such parameters, the model was found to adequately describe mixed systems including 5–6 dicarboxylic acids, down to low relative humidity conditions. The additive approach for modelling mixed inorganic/organic systems worked well for a variety of mixtures. As expected, deviations between predicted and measured data increase with increasing concentration. Available surface tension models, used in evaluating the Kelvin term, were found to reproduce measured data with varying success. Deviations from experimental data increased with increased organic compound complexity. For components only slightly soluble in water, significant deviations from measured surface tension depression behaviour were predicted with both model formalisms tested. A Sensitivity analysis showed that such variation is likely to lead to predicted growth factors within the measurement uncertainty for growth factor taken in the sub-saturated regime. Greater sensitivity was found for the value of dry density used in the assumed form of the dried out aerosol. Comparison with a coupled thermodynamic approach showed that assumed values for interactions parameters may lead to erroneous results where a simple additive approach may provide more accurate results. However, where available, the use of coupled thermodynamics can better reproduce measured behaviour. Further work (and laboratory data) is required to assess whether this difference lies within the experimental uncertainty of observed hygroscopic behaviour for a variety of systems.

Citation: Topping, D. O., McFiggans, G. B., and Coe, H.: A curved multi-component aerosol hygroscopicity model framework: 2 – Including organics, Atmos. Chem. Phys. Discuss., 4, 8677-8726, doi:10.5194/acpd-4-8677-2004, 2004.
 
Search ACPD
Discussion Paper
    XML
    Citation
    Final Revised Paper
    Share