Atmos. Chem. Phys. Discuss., 10, 12859-12906, 2010
www.atmos-chem-phys-discuss.net/10/12859/2010/
doi:10.5194/acpd-10-12859-2010
© Author(s) 2010. This work is distributed
under the Creative Commons Attribution 3.0 License.
Review Status
This discussion paper has been under review for the journal Atmospheric Chemistry and Physics (ACP). Please refer to the corresponding final paper in ACP.
Evaluation of the carbon content of aerosols from the burning of biomass in the Brazilian Amazon using thermal, optical and thermal-optical analysis methods
L. L. Soto-García1,2, M. O. Andreae3, T. W. Andreae3, P. Artaxo4, W. Maenhaut5, T. Kirchstetter6, T. Novakov6, J. C. Chow7, and O. L. Mayol-Bracero1
1Institute for Tropical Ecosystem Studies, University of Puerto Rico, San Juan, Puerto Rico
2Department of Chemistry, University of Puerto Rico, San Juan, Puerto Rico
3Biogeochemistry Department, Max Planck Institute for Chemistry, Mainz, Germany
4Institute for Physics, University of São Paulo, São Paulo, Brazil
5Institute for Nuclear Sciences, Ghent University, Ghent, Belgium
6Lawrence Berkeley National Laboratory, Berkeley, California, USA
7Desert Research Institute, Reno, Nevada, USA

Abstract. Aerosol samples were collected at a pasture site in the Amazon Basin as part of the project LBA-SMOCC-2002 (Large-Scale Biosphere-Atmosphere Experiment in Amazonia – Smoke Aerosols, Clouds, Rainfall and Climate: Aerosols from Biomass Burning Perturb Global and Regional Climate). Sampling was conducted during the late dry season, when the aerosol composition was dominated by biomass burning emissions, especially in the submicron fraction. A 13-stage Dekati low-pressure impactor (DLPI) was used to collect particles with nominal aerodynamic diameters ranging from 0.03 to 0.10 μm. Gravimetric analyses of the DLPI substrates and filters were performed to obtain aerosol mass concentrations. The concentrations of total, apparent elemental, and organic carbon (TC, ECa, and OC) were determined using thermal and thermal-optical analysis (TOA) methods. A light transmission method (LTM) was used to determine the concentration of equivalent black carbon (BCe) or the absorbing fraction at 880 nm for the size-resolved samples.

During the dry period, due to the pervasive presence of fires in the region upwind of the sampling site, concentrations of fine aerosols (Dp < 2.5 μm: average 59.8 μg m−3) were higher than coarse aerosols (Dp > 2.5 μm: 4.1 μg m−3). Carbonaceous matter, estimated as the sum of the particulate organic matter (i.e., OC×1.8) plus BCe, comprised more than 90% to the total aerosol mass. Concentrations of ECa (estimated by thermal analysis with a correction for charring) and BCe (estimated by LTM) averaged 5.2±1.3 and 3.1±0.8 μg m−3, respectively. The determination of EC was improved by extracting water soluble organic material from the samples, which reduced the average light absorption Ångström exponent of particles in the size range of 0.1 to 1.0 μm from being greater than 2.0 to approximately 1.2. The size-resolved BCe measured by the LTM showed a clear maximum between 0.4 to 0.6 μm in diameter. The concentrations of OC and BCe varied diurnally during the dry period, and this variation is related to diurnal changes in boundary layer thickness and in fire frequency.


Citation: Soto-García, L. L., Andreae, M. O., Andreae, T. W., Artaxo, P., Maenhaut, W., Kirchstetter, T., Novakov, T., Chow, J. C., and Mayol-Bracero, O. L.: Evaluation of the carbon content of aerosols from the burning of biomass in the Brazilian Amazon using thermal, optical and thermal-optical analysis methods, Atmos. Chem. Phys. Discuss., 10, 12859-12906, doi:10.5194/acpd-10-12859-2010, 2010.
 
Search ACPD
Discussion Paper
    XML
    Citation
    Final Revised Paper
    Share